The products in this section are typically used to reconstruct or fabricate composite panels. The "how, when, and why" these products are used, the methods, and the "expectations " are the responsibility of the purchaser. Purchasers should become knowledgeable on the use of Personal Protection equipment (goggles, gloves, respirators etc), and handling chemical compounds (glues, adhesives, solvents, etc.) before use of these products. 

In general...

...the Composet Compobond® is used to bond wood, metal, fiberglass, and Styrofoam. It is 2-component epoxy with a paste consistency allowing for minor surface variations. The best way to apply is using the trowel, spreader, and roller sleeve supplied in the kit. It can be pumped with a syringe or caulk gun to some degree, and the PLUS kits include this capability. Surface preparation, temperature controls, fixturing/clamping, and cure time should be considered. 

...Stabond® products are 1-component solvent-based contact cements. The adhesive is applied to both surfaces to be bonded. After an "open time" time the parts are mated and the bond is immediate, there is no adjustment. Typically the best way to apply this product is by spray.

...the Composet SLV® resin is used to bond wood, metal, fiberglass, and Styrofoam. It is 2-component epoxy with a very thing consistency requiring very close fitting parts with minimal gaps. Surface preparation, temperature controls, fixturing/clamping, and cure time should be considered. Panel Fabrication Kits with the Composet SLV resin are custom orders and not stocked.